This is a photo album of my RV - 4.

I will be putting notes and explanatory pictures as I build this air plane.

E - Mail Me

Saturday, January 26, 2013

To Do / To Buy

Elevator trim cable is too short.
Setup elevator end stops. Manual is not very clear on this.
Alternator / Generator Drill Mounting bracket.
Cabin Heat Muff ?
Cabin Air Vent
Pump for Brake Bleed.
Stall Warning Sender / Lamp
Angle Drill
Watyl Primer
Washers Engine Mount Upper


$ :
1 x ICOM 210A
1 x Stud on starter
2 x 3/16 bore 3.8 HEIM 3614M Rod End - Aileron Push Rod
1 x VA111 Threaded Rod End - Aileron Push Rod
1 x Nut on Exhaust Clamp - not nylock
 4 x Washers Engine Mount Upper
2 x Rudder Cables - lifed out - F-452-LX166
1 x Clevis End - Elevator Trim            
1 x PPT Switch
1 x Push Rod - same thread as AN3 - Rear Throttle
1 x 2 inch hose clamp / Carby Heat Muff.
1 x 44 inch Hinge Canopy Rail
Tacho Cable firewall fairlead


Spar Bolts:
14 x NAS 1306-30
2 x NAS 1306-32
2 x NAS 1304-30
2 x NAS 1304-32
16 x AN4-17A
12 x AN4-16A
1 x Fuel Cap
2 x O rings spares
2 x Fuel Qty Sender

No comments:

Post a Comment